Home Authors Posts by Vic Syracuse

Vic Syracuse

Vic Syracuse
214 POSTS 8 COMMENTS
Vic is a fixed-wing and helicopter commercial pilot, CFII with ASMEL/ASES ratings, an A&P/IA, DAR, and EAA technical advisor and flight counselor. Passionately involved in aviation for over 40 years, he has built 11 aircraft and logged over 10,000 hours in 72 different kinds of aircraft. Vic volunteers as a Young Eagle pilot, has his own sport aviation business called Base Leg Aviation, and has written two books on aircraft prebuy and condition inspections.

Improper Deburring

4
It is really important to remove the burrs that are created when drilling through aluminum prior to riveting. Otherwise the rivets will not get...

Improper Bolt Length

1
A bolt should extend beyond the nut by 1–3 threads. If it is any longer, then the next size shorter bolt should be used....

Horizontal Stabilizer Crack

1
In 2014 Van’s Aircraft put out a service bulletin for potential cracking in the horizontal stabilizers of the RV-6, RV-7 and RV-8 series of...

Turnbuckle Safety Wire

2
Turnbuckles are usually used in control systems to apply the proper amount of tension to the cables. It is extremely important to ensure that...

Leaky Static Lines

1
Ever wonder why static systems often start to leak after a couple of years? See the little plastic insert between the two tubes in...

Missing Rivets

3
This is the root rib on a horizontal stabilizer. The rivets that fasten the rib to the spar are completely missing!

Jam Nut Triple Threat

1
Jam nuts serve a purpose and that is to prevent actuating arms from becoming disconnected. I found three examples on the same airplane. Two...

Past Due ELT Batteries

0
There is a requirement for an annual ELT check to be entered into the aircraft logbooks. The batteries must be replaced prior to the...
Rotax engine education

Rotax Training for the 9 Series

5
Lockwood Aviation helps you get a full understanding of the four-stroke Rotax.

Low Compression

0
Usually, we look for something greater than 60/80 when doing compression checks on Lycoming engines. A reading such as this one (36/80) really warrants...

In Case You Missed It

Home Shop Machinist

0
Kermit Weeks hangar—EAA’s home shop.

Contributors

0
dan CheckowayMeet Checkoway for a cup of coffee and some peach cobbler at Flos...

All Wrapped Up

0
An illustrated guide to safetying turnbuckles.

All About Avionics, Part 9

0
One of the final steps in getting your avionics suite to work is installation of some sort of antenna to capture various radio frequencies. Failing to choose the right antenna and install it properly can compromise the whole installation. Rather than focusing on the intricacies of antenna design, the author discusses the merits of internal versus external for particular equipment plus where to place them; by Stein Bruch